Service Hotline:86-752-5199615

此页面上的内容需要较新版本的 Adobe Flash Player。

获取 Adobe Flash Player



Tel: 86-752-5199615      Fax: 86-752-5199613


Add: 23 Shihua Avenue West, Daya Bay Development
Area, Huizhou, Guangdong

Two-dimensional code
ITO Glass
Home >> ProductClassic >>ITO Glass
1.Basic Concept:
On the surface of the common glass coated with a layer of indium tin oxide conductive film, to form the indium tin oxide glass which common used in LCD, usually referred to as ITO glass.
        ITO as nanometer indium tin oxide, has good conductivity and transparency, can cut off the harmful electromagnetic radiation, ultraviolet light and far infrared ray to human body. Therefore, after spraying in glass, plastic and electronic display screen, not only keep them to enhance conductivity and transparency and also to cut off harmful electronic radiation, ultraviolet and infrared to human body at the same time.
        ITO conductive glass is on the basis of the calcium-sodium or borosilicate substrate, using the method of magnetron sputtering plating a layer of indium tin oxide (commonly known as ITO) film. Processing LCD special ITO conductive glass, before plating ITO layer, also plating a 20-30 nm thick layer of silicon dioxide as the barrier layer, the main effect is to prevent the metal ion in the calcium-sodium substrate diffusion penetration to the ITO layer, it will effect the conductivity of ITO layer. High-grade LCD special used ITO glass, in order to get a more uniform display control, before sputtering ITO layer, the substrate glass need to be polished.
        The advanced ITO coating production line and mature management of processing technology, JMT can produce high and low resistance TN\STN of ITO conductive glass (the minimum 3 ohm ultra-low resistance ITO glass) and the ITO glass for touch screen, optical shadow elimination ITO glass, OGS monolithic (BM + ITO) coated glass, OGS large (BM+ ITO) coated glass, TFT low-temperature ITO coated glass etc.
       ITO conductive glass is widely used in electronics, LCD touch screen products, high-grade products.
3.Processing size:
14''x 14'' \ 14'' x 16'' \ 300x 360mm \300x 350mm \370x 470mm \400x 500mm
 Thickness: 0.4mm—1.1mm (according to customers’ requirements)  
4.Toughened standards: 
GB/T9963-1998   BS6206   ANSI Z97.1-2004   EN12150


Copyright 2014 JMTGLASS.All right Reserved Site Design CTO.LTD